Endress+Hauser Proline Promag 300 - The Current Input Module Does Not Use any Terminal Numbers

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 105
Signal mode (0377–1 to n)
→  105
Assign curr. 1 to n (0359–1 to n)
→  106
Current span (0353–1 to n)
→  106
Fixed current (0365–1 to n)
→  107
0/4 mA value (0367–1 to n)
→  108
20 mA value (0372–1 to n)
→  109
Measuring mode (0351–1 to n)
→  110
Damping out. 1 to n (0363–1 to n)
→  114
Response time (0378–1 to n)
→  115
Failure mode (0364–1 to n)
→  116
Failure current (0352–1 to n)
→  117
Output curr. 1 to n (0361–1 to n)
→  117
Measur. curr. 1 to n (0366–1 to n)
→  118
Terminal no.
Navigation  Expert → Output → Curr.output 1 to n → Terminal no. (0379–1 to n)
Description Displays the terminal numbers used by the current output module.
User interface • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
Additional information "Not used" option
The current output module does not use any terminal numbers.
Signal mode 
Navigation  Expert → Output → Curr.output 1 to n → Signal mode (0377–1 to n)
Description Use this function to select the signal mode for the current output.