Endress+Hauser Proline Promag 300 - Page 116

Description of device parameters Proline Promag 300 Modbus RS485
116 Endress+Hauser
Failure mode 
Navigation  Expert → Output → Curr.output 1 to n → Failure mode (0364–1 to n)
Prerequisite One of the following options is selected in the Assign curr. parameter (→  106):
• Volume flow
• Mass flow
• Correct.vol.flow
• Flow velocity
• Conductivity
*
• CorrConductivity
*
• Temperature
*
• Electronic temp.
One of the following options is selected in the Current span parameter (→  106):
• 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
Description Use this function to select the value of the current output in the event of a device alarm.
Selection • Min.
• Max.
• Last valid value
• Actual value
• Defined value
Factory setting Max.
* Visibility depends on order options or device settings