Endress+Hauser Proline Promag 300 - Switch-On Value; Switch-Off Value

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 135
Switch-on value 
Navigation  Expert → Output → PFS output 1 to n → Switch-on value (0466–1 to n)
Prerequisite • In the Operating mode parameter (→  120), the Switch option is selected.
• In the Switch out funct parameter (→  132), the Limit option is selected.
Description Use this function to enter the measured value for the switch-on point.
User entry Signed floating-point number
Factory setting Country-specific:
• 0 l/h
• 0 gal/min (us)
Additional information Description
Use this function to enter the limit value for the switch-on value (process variable >
switch-on value = closed, conductive).
When using a hysteresis: Switch-on value > Switch-off value.
Dependency
The unit depends on the process variable selected in the Assign limit parameter
(→  133).
Switch-off value 
Navigation  Expert → Output → PFS output 1 to n → Switch-off value (0464–1 to n)
Prerequisite • In the Operating mode parameter (→  120), the Switch option is selected.
• In the Switch out funct parameter (→  132), the Limit option is selected.
Description Use this function to enter the measured value for the switch-off point.
User entry Signed floating-point number
Factory setting Country-specific:
• 0 l/h
• 0 gal/min (us)
Additional information Description
Use this function to enter the limit value for the switch-off value (process variable <
switch-off value = open, non-conductive).
When using a hysteresis: Switch-on value > Switch-off value.
Dependency
The unit depends on the process variable selected in the Assign limit parameter
(→  133).