Endress+Hauser Proline Promag 300 - Maximum Value

Description of device parameters Proline Promag 300 Modbus RS485
200 Endress+Hauser
Additional information Dependency
The unit is taken from the Temperature unit parameter (→  58)
Maximum value
Navigation  Expert → Diagnostics → Min/max val. → Main elect.temp. → Maximum value
(6545)
Description Displays the highest previously measured temperature value of the main electronics
module.
User interface Signed floating-point number
Additional information Dependency
The unit is taken from the Temperature unit parameter (→  58)
"Temperature" submenu
Navigation  Expert → Diagnostics → Min/max val. → Temperature
‣
Temperature
Minimum value (6681)
→  200
Maximum value (6680)
→  201
Minimum value
Navigation  Expert → Diagnostics → Min/max val. → Temperature → Minimum value (6681)
Prerequisite One of the following conditions is met:
• Order code for "Sensor option", option CI "Medium temperature measurement"
or
• The temperature is read into the flowmeter from an external device.
Description Displays the lowest previously measured medium temperature value.
User interface Signed floating-point number
Additional information Dependency
The unit is taken from the Temperature unit parameter (→  58)