Endress+Hauser Proline Promag 300 - Minimum Value; Reset Min;Max

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 199
3.8.12 "Min/max val." submenu
Navigation  Expert → Diagnostics → Min/max val.
‣
Min/max val.
Reset min/max (6541)
→  199
‣
Main elect.temp.
→  199
‣
Temperature
→  200
Reset min/max 
Navigation  Expert → Diagnostics → Min/max val. → Reset min/max (6541)
Description Use this function to select measured variables whose minimum, maximum and average
measured values are to be reset.
Selection • Cancel
• Terminal volt.
• IO module temp.
Factory setting Cancel
"Main elect.temp." submenu
Navigation  Expert → Diagnostics → Min/max val. → Main elect.temp.
‣
Main elect.temp.
Minimum value (6547)
→  199
Maximum value (6545)
→  200
Minimum value
Navigation  Expert → Diagnostics → Min/max val. → Main elect.temp. → Minimum value (6547)
Description Displays the lowest previously measured temperature value of the main electronics
module.
User interface Signed floating-point number