Endress+Hauser Proline Promag 300 - Diagnostic No. 835 (Process Temp.); Diagnostic No. 937 (EMC Interference); Diagnostic No. 938 (EMC Interference)

Description of device parameters Proline Promag 300 Modbus RS485
38 Endress+Hauser
Diagnostic no. 835 (Process temp.) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 835 (0702)
Description Use this function to change the diagnostic behavior of the diagnostic message 835 Process
temp..
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Warning
Additional information For a detailed description of the options available, see →  32
Diagnostic no. 937 (EMC interference) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 937 (0743)
Description Use this function to change the diagnostic behavior of the diagnostic message 937 EMC
interference.
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Warning
Additional information For a detailed description of the options available, see →  32
Diagnostic no. 938 (EMC interference) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 938 (0642)
Description Option for changing the diagnostic behavior of the diagnostic message 938 EMC
interference.
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Alarm
Additional information For a detailed description of the options available, see →  32