Endress+Hauser Proline Promag 300 - 0% Bargraph 3 (0124); 100% Bargraph 3

Description of device parameters Proline Promag 300 Modbus RS485
22 Endress+Hauser
0% bargraph 3 
Navigation  Expert → System → Display → 0% bargraph 3 (0124)
Prerequisite A selection was made in the Value 3 display parameter (→  21).
Description Use this function to enter the 0% bar graph value to be shown on the display for the
measured value 3.
User entry Signed floating-point number
Factory setting Country-specific:
• 0 l/h
• 0 gal/min (us)
Additional information Description
The Format display parameter (→  16) is used to specify that the measured value
is to be displayed as a bar graph.
User entry
The unit of the displayed measured value is taken from the System units submenu
(→  55).
100% bargraph 3 
Navigation  Expert → System → Display → 100% bargraph 3 (0126)
Prerequisite A selection was made in the Value 3 display parameter (→  21).
Description Use this function to enter the 100% bar graph value to be shown on the display for the
measured value 3.
User entry Signed floating-point number
Factory setting 0
Additional information Description
The Format display parameter (→  16) is used to specify that the measured value
is to be displayed as a bar graph.
User entry
The unit of the displayed measured value is taken from the System units submenu
(→  55).