Description of device parameters Proline Promag 300 Modbus RS485
16 Endress+Hauser
Format display
Navigation Expert → System → Display → Format display (0098)
Prerequisite A local display is provided.
Description Use this function to select how the measured value is shown on the local display.
Selection • 1 value, max.
• Bargr. + 1 value
• 2 values
• Val. large+2val.
• 4 values
Factory setting 1 value, max.
Additional information Description
The display format (size, bar graph etc.) and number of measured values displayed
simultaneously (1 to 4) can be configured. This setting only applies to normal operation.
• The Value 1 display parameter (→ 18) to Value 4 display parameter
(→ 23) are used to specify which measured values are shown on the local
display and in what order.
• If more measured values are specified than the display mode selected permits, then
the values alternate on the device display. The display time until the next change is
configured via the Display interval parameter (→ 24).
Custody transfer mode
Only available for Promag H.
• Once the measuring device has been enabled for custody transfer mode, depending on
the custody transfer approval selected the display can switch between showing the
relevant information and the custody transfer counter.
• In addition, a padlock symbol appears in the header of the display ().
For detailed information on custody transfer mode, see the Special Documentation for
the device → 7
To Next Page
Loading...
