Endress+Hauser Proline Promag 300 - Diagnostic No. 376 (Sensor Electron.); Diagnostic No. 377 (Sensor Electron.); Diagnostic No. 441 (Curr.output 1 to N)

Description of device parameters Proline Promag 300 Modbus RS485
34 Endress+Hauser
Diagnostic no. 376 (Sensor electron.) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 376 (0645)
Description Option for changing the diagnostic behavior of the diagnostic message 376 Sensor
electron..
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Warning
Additional information For a detailed description of the options available, see →  32
Diagnostic no. 377 (Sensor electron.) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 377 (0777)
Description Option for changing the diagnostic behavior of the diagnostic message 377 Sensor
electron..
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Warning
Additional information For a detailed description of the options available, see →  32
Diagnostic no. 441 (Curr.output 1 to n) 
Navigation  Expert → System → Diagn. handling → Diagn. behavior → Diagnostic no. 441 (0657)
Description Use this function to change the diagnostic behavior of the diagnostic message
441 Curr.output 1 to n.
Selection • Off
• Alarm
• Warning
• Logbook only
Factory setting Warning
Additional information For a detailed description of the options available, see →  32