Endress+Hauser Proline Promag 300 - Flow Vel. Factor; Nominal Diameter; Calibration Submenu

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 95
Flow vel. factor 
Navigation  Expert → Sensor → Sensor adjustm. → Variable adjust → Flow vel. factor (1880)
Description Use this function to enter a quantity factor (without time) for the flow velocity. This
multiplication factor is applied over the flow velocity range.
User entry Positive floating-point number
Factory setting 1
Additional information Description
Corrected value = (factor × value) + offset
3.2.6 "Calibration" submenu
Navigation  Expert → Sensor → Calibration
‣
Calibration
Nominal diameter (2807)
→  95
Cal. factor (6522)
→  96
Zero point (6546)
→  96
Cond. cal. fact. (6718)
→  96
Nominal diameter
Navigation  Expert → Sensor → Calibration → Nominal diameter (2807)
Description Displays the nominal diameter of the sensor.
User interface DNxx / x"
Factory setting Depends on the size of the sensor
Additional information Description
The value is also specified on the sensor nameplate.