Endress+Hauser Proline Promag 300 - Value 2 Display

Description of device parameters Proline Promag 300 Modbus RS485
20 Endress+Hauser
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xx
Additional information Description
This setting does not affect the measuring or computational accuracy of the device.
The arrow displayed between the measured value and the unit indicates that the
device computes with more digits than are shown on the local display.
Value 2 display 
Navigation  Expert → System → Display → Value 2 display (0108)
Prerequisite A local display is provided.
Description Use this function to select one of the measured values to be shown on the local display.
Selection • None
• Volume flow
• Mass flow
• Correct.vol.flow
• Flow velocity
• Conductivity
*
• CorrConductivity
*
• Temperature
*
• Electronic temp.
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Curr.output 1
• Curr.output 2
*
• Curr.output 3
*
• Curr.output 4
*
• Cust.trans.count
*
Factory setting None
Additional information Description
If several measured values are displayed at once, the measured value selected here will be
the second value to be displayed. The value is only displayed during normal operation.
The Format display parameter (→  16) is used to specify how many measured
values are displayed simultaneously and how.
Dependency
The unit of the displayed measured value is taken from the System units submenu
(→  55).
* Visibility depends on order options or device settings