Endress+Hauser Proline Promag 300 - Assign Curr. 1 to N

Description of device parameters Proline Promag 300 Modbus RS485
106 Endress+Hauser
Selection • Passive
• Active
Factory setting Active
Assign curr. 1 to n 
Navigation  Expert → Output → Curr.output 1 to n → Assign curr. 1 to n (0359–1 to n)
Description Use this function to select a process variable for the current output.
Selection • Off
• Volume flow
• Mass flow
• Correct.vol.flow
• Flow velocity
• Conductivity
*
• CorrConductivity
*
• Temperature
*
• Electronic temp.
Factory setting Volume flow
Current span 
Navigation  Expert → Output → Curr.output 1 to n → Current span (0353–1 to n)
Description Use this function to select the current range for the process value output and the upper
and lower level for signal on alarm.
Selection • 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
• Fixed current
Factory setting Country-specific:
• 4...20 mA NAMUR
• 4...20 mA US
* Visibility depends on order options or device settings