Endress+Hauser Proline Promag 300 - Alteration Code; Apply I;O Config; I;O 1 to N Type

Description of device parameters Proline Promag 300 Modbus RS485
98 Endress+Hauser
I/O 1 to n type 
Navigation  Expert → I/O config. → I/O 1 to n type (3901–1 to n)
Prerequisite For the following order code:
• "Output; input 2", option D "Configurable I/O initial setting off"
• "Output; input 3", option D "Configurable I/O initial setting off"
Description Use this function to select the I/O module type for the configuration of the I/O module.
Selection • Off
• Curr.output
*
• Current input
*
• Status input
*
• PFS output
*
Factory setting Off
Apply I/O config 
Navigation  Expert → I/O config. → Apply I/O config (3907)
Description Use this function to activate the newly configured I/O module type.
Selection • No
• Yes
Factory setting No
Alteration code 
Navigation  Expert → I/O config. → Alteration code (2762)
Description Use this function to enter the ordered activation code to activate the I/O configuration
change.
User entry Positive integer
Factory setting 0
Additional information Description
The I/O configuration is changed in the I/O type parameter (→  98).
* Visibility depends on order options or device settings