Endress+Hauser Proline Promag 300 - Density Source; External Density; Fixed Density

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 85
Density source 
Navigation  Expert → Sensor → External comp. → Density source (6615)
Description Use this function to select the density source.
Selection • Fixed density
• Current input 1
*
• Current input 2
*
• Current input 3
*
• External density
• Calculated value
Factory setting Fixed density
External density
Navigation  Expert → Sensor → External comp. → External density (6630)
Prerequisite The External density option is selected in the Density source parameter (→  85).
Description Use this function to enter the density read in from the external device.
User entry Positive floating-point number
Factory setting 0 kg/l
Additional information Dependency
The unit is taken from the Density unit parameter (→  60)
Fixed density 
Navigation  Expert → Sensor → External comp. → Fixed density (6623)
Prerequisite The Fixed density option is selected in the Density source parameter (→  85).
Description Use this function to enter a fixed value for the density.
User entry Positive floating-point number
Factory setting Country-specific:
• 1 000 kg/l
• 1 000 lb/ft³
* Visibility depends on order options or device settings