Endress+Hauser Proline Promag 300 - Unit Totalizer 1 to N

Description of device parameters Proline Promag 300 Modbus RS485
168 Endress+Hauser
Unit totalizer 1 to n 
Navigation  Expert → Application → Totalizer 1 to n → Unit totalizer 1 to n (0915–1 to n)
Prerequisite One of the following options is selected in the Assign variable parameter (→  167) of
the Totalizer 1 to n submenu:
• Volume flow
• Mass flow
• Correct.vol.flow
Description Use this function to select the process variable unit for the Totalizer 1 to n (→  167).
Selection SI units
• g
• kg
• t
US units
• oz
• lb
• STon
or
SI units
• cm³
• dm³
• m³
• ml
• l
• hl
• Ml Mega
US units
• af
• ft³
• fl oz (us)
• gal (us)
• kgal (us)
• Mgal (us)
• bbl (us;liq.)
• bbl (us;beer)
• bbl (us;oil)
• bbl (us;tank)
Imperial units
• gal (imp)
• Mgal (imp)
• bbl (imp;beer)
• bbl (imp;oil)
or
SI units
• Nl
• Nm³
• Sm³
US units
• Sft³
• Sgal (us)
• Sbbl (us;liq.)
Imperial units
Sgal (imp)
or
Other units
None
Factory setting l
Additional information Description
The unit is selected separately for each totalizer. It is independent of the selection
made in the System units submenu (→  55).
Selection
The selection is dependent on the process variable selected in the Assign variable
parameter (→  167).