Endress+Hauser Proline Promag 300 - Corrconductivity; Temperature; Density

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 47
CorrConductivity
Navigation  Expert → Sensor → Measured val. → Process variab. → CorrConductivity (1853)
Prerequisite One of the following conditions is met:
• Order code for "Sensor option", option CI "Medium temperature measurement"
or
• The temperature is read into the flowmeter from an external device.
Description Displays the conductivity currently corrected.
User interface Positive floating-point number
Additional information Dependency
The unit is taken from the Conductiv. unit parameter (→  57)
Temperature
Navigation  Expert → Sensor → Measured val. → Process variab. → Temperature (1852)
Prerequisite One of the following conditions is met:
• Order code for "Sensor option", option CI "Medium temperature measurement"
or
• The temperature is read into the flowmeter from an external device.
Description Displays the temperature currently calculated.
User interface Positive floating-point number
Additional information Dependency
The unit is taken from the Temperature unit parameter (→  58)
Density
Navigation  Expert → Sensor → Measured val. → Process variab. → Density (1857)
Description Displays the current fixed density or density read in from an external device.
User interface Signed floating-point number
Additional information Dependency
The unit is taken from the Density unit parameter (→  60)