Endress+Hauser Proline Promag 300 - Diag. Event Sim.; Event Category

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 211
Event category 
Navigation  Expert → Diagnostics → Simulation → Event category (0738)
Description Use this function to select the category of the diagnostic events that are displayed for the
simulation in the Diag. event sim. parameter (→  211).
Selection • Sensor
• Electronics
• Configuration
• Process
Factory setting Process
Diag. event sim. 
Navigation  Expert → Diagnostics → Simulation → Diag. event sim. (0737)
Description Use this function to select a diagnostic event for the simulation process that is activated.
Selection • Off
• Diagnostic event picklist (depends on the category selected)
Factory setting Off
Additional information Description
For the simulation, you can choose from the diagnostic events of the category selected
in the Event category parameter (→  211).