Endress+Hauser Proline Promag 300 - Data Log. Status; Logging Duration

Description of device parameters Proline Promag 300 Modbus RS485
196 Endress+Hauser
Data log. status
Navigation  Expert → Diagnostics → Data logging → Data log. status (0858)
Prerequisite In the Data logging parameter (→  194), the Not overwriting option is selected.
Description Displays the measured value logging status.
User interface • Done
• Delay active
• Active
• Stopped
Factory setting Done
Additional information Selection
• Done
Measured value logging has been performed and completed successfully.
• Delay active
Measured value logging has been started but the logging interval has not yet elapsed.
• Active
The logging interval has elapsed and measured value logging is active.
• Stopped
Measured value logging is stopped.
Logging duration
Navigation  Expert → Diagnostics → Data logging → Logging duration (0861)
Prerequisite In the Data logging parameter (→  194), the Not overwriting option is selected.
Description Displays the total logging duration.
User interface Positive floating-point number
Factory setting 0 s
"Displ.channel 1" submenu
Navigation  Expert → Diagnostics → Data logging → Displ.channel 1
▸ Displ.channel 1
Display channel 1
→  197