Endress+Hauser Proline Promag 300 - Density Offset; Density Factor; Spec. Enth. Text

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 67
User entry Max. 10 characters such as letters, numbers or special characters (@, %, /)
Factory setting User dens.
Additional information Result
The defined unit is shown as an option in the choose list of the Density unit
parameter (→  60).
Example
Enter text “CE_L” for centners per liter
Density offset 
Navigation  Expert → Sensor → System units → User-spec. units → Density offset (0571)
Description Use this function to enter the zero point shift for the user-specific density unit.
Value in user-specific unit = (factor × value in base unit) + offset
User entry Signed floating-point number
Factory setting 0
Density factor 
Navigation  Expert → Sensor → System units → User-spec. units → Density factor (0572)
Description Use this function to enter a quantity factor for the user-specific density unit.
User entry Signed floating-point number
Factory setting 1.0
Spec. enth. text 
Navigation  Expert → Sensor → System units → User-spec. units → Spec. enth. text (0585)
User entry Max. 10 characters such as letters, numbers or special characters (@, %, /)
Factory setting User enth.