Endress+Hauser Proline Promag 300 - Temp. Offset; Temp. Factor

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 93
Additional information Description
Corrected value = (factor × value) + offset
Temp. offset 
Navigation  Expert → Sensor → Sensor adjustm. → Variable adjust → Temp. offset (1868)
Prerequisite One of the following conditions is met:
• Order code for "Sensor option", option CI "Medium temperature measurement"
or
• The temperature is read into the flowmeter from an external device.
Description Use this function to enter the zero point shift for the temperature trim. The temperature
unit on which the shift is based is 1 K.
User entry Signed floating-point number
Factory setting 0 K
Additional information Description
Corrected value = (factor × value) + offset
Temp. factor 
Navigation  Expert → Sensor → Sensor adjustm. → Variable adjust → Temp. factor (1869)
Prerequisite One of the following conditions is met:
• Order code for "Sensor option", option CI "Medium temperature measurement"
or
• The temperature is read into the flowmeter from an external device.
Description Use this function to enter a quantity factor (without time) for the temperature. This
multiplication factor is applied over the temperature range.
User entry Positive floating-point number
Factory setting 1
Additional information Description
Corrected value = (factor × value) + offset