Endress+Hauser Proline Promag 300 - Page 119

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 119
Response time (0491–1 to n)
→  130
Failure mode (0451–1 to n)
→  130
Failure freq. (0474–1 to n)
→  131
Output freq. 1 to n (0471–1 to n)
→  131
Switch out funct (0481–1 to n)
→  132
Assign diag. beh (0482–1 to n)
→  132
Assign limit (0483–1 to n)
→  133
Switch-on value (0466–1 to n)
→  135
Switch-off value (0464–1 to n)
→  135
Assign dir.check (0484–1 to n)
→  136
Assign status (0485–1 to n)
→  136
Switch-on delay (0467–1 to n)
→  136
Switch-off delay (0465–1 to n)
→  137
Failure mode (0486–1 to n)
→  137
Switch status 1 to n (0461–1 to n)
→  137
Invert outp.sig. (0470–1 to n)
→  138
Terminal no.
Navigation  Expert → Output → PFS output 1 to n → Terminal no. (0492–1 to n)
Description Displays the terminal numbers used by the pulse/frequency/switch output module.
User interface • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
Additional information "Not used" option
The pulse/frequency/switch output module does not use any terminal numbers.