Endress+Hauser Proline Promag 300 - Page 259

Proline Promag 300 Modbus RS485 Modbus RS485 Register Information
Endress+Hauser 259
"I/O module 3" submenu
Navigation: Expert → Diagnostics → I/O module 3
Parameter Register Data type Access Selection / User entry / User interface → 
I/O 3 terminals (3902–3) 6543 Integer Read 0 = Not used
1 = 26-27 (I/O 1)
2 = 24-25 (I/O 2)
3 = 22-23 (I/O 3)
187
Software rev. (0072) 7039 Integer Read Positive integer 187
"Display module" submenu
Navigation: Expert → Diagnostics → Display module
Parameter Register Data type Access Selection / User entry / User interface → 
Software rev. (0072) 7039 Integer Read Positive integer 190
"Min/max val." submenu
Navigation: Expert → Diagnostics → Min/max val.
Parameter Register Data type Access Selection / User entry / User interface → 
Reset min/max (6541) Integer Read / Write 0 = Cancel
0 = Terminal volt.
0 = IO module temp.
199
"Main elect.temp." submenu
Navigation: Expert → Diagnostics → Min/max val. → Main elect.temp.
Parameter Register Data type Access Selection / User entry / User interface → 
Minimum value (6547) 2292 to 2293 Float Read Signed floating-point number 199
Maximum value (6545) 2294 to 2295 Float Read Signed floating-point number 200
"Temperature" submenu
Navigation: Expert → Diagnostics → Min/max val. → Temperature
Parameter Register Data type Access Selection / User entry / User interface → 
Minimum value (6681) 2339 to 2340 Float Read Signed floating-point number 200
Maximum value (6680) 2337 to 2338 Float Read Signed floating-point number 201