Command Line Interface
10151553-KDU 137 365 Uen D 2006-06-16
7.25 IP Interface Commands
An IP address may be used for management access to the ECN330-switch over
the network or to connect the ECN330-switch to existing IP subnets. By default,
there are no IP addresses assigned to the , it uses DHCP to obtain IP settings
for VLAN 247. A default gateway may also need to be established between the
ECN330-switch and management stations that exist on other network segments
(if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to
connect subnetworks to the enterprise network.
Table 122 IP Interface Commands
Basic IP Configuration
This section describes commands used to configure IP addresses for VLAN
interfaces on the ECN330-switch.
Table 123 Basic IP Configuration Commands
Command Group Function Page
Basic IP
Configuration
Configures the IP address for interfaces and the gateway
router
1015
Address Resolution
Protocol (ARP)
Configures static, dynamic and proxy ARP service 1023
Command Function Mode Page
ip address Sets the IP address for the current interface IC 1016
ip default-
gateway
Defines the default gateway through which the
ECN330-switch can reach other subnetworks
GC 1018
show ip
interface
Displays the IP settings for the ECN330-switch PE 1019
To Next Page
Loading...
