Ericsson ECN330 - Resetting the System

Configuring the ECN330-switch
1031553-KDU 137 365 Uen D 2006-06-16
CLI – Enter the IP address of at least one SMTP server, set the syslog severity
level to trigger an email message, and specify the ECN330-switch (source) and
up to five recipient (destination) email addresses. Enable SMTP with the
logging sendmail command to complete the configuration. Use the show
logging sendmail command to display the current SMTP configuration.
6.3.14 Resetting the System
Web – Click System, Reset. Click the Reset button to restart the ECN330-
switch. When prompted, confirm to reset the ECN330-switch.
Figure 30 Resetting the System
Console(config)#logging sendmail host 192.168.1.4
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
big-wheels@matel.com
Console(config)#logging sendmail destination-email
chris@matel.com
Console(config)#logging sendmail
Console(config)#exit
Console#show logging sendmail
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. chris@matel.com
SMTP source email address: big-wheels@matel.com
SMTP status: Enabled
Console#