Configuring the ECN330-switch
691553-KDU 137 365 Uen D 2006-06-16
6.3 System Management Configuration
6.3.1 Displaying System Information
The system can be identified by displaying the device name, location and
contact information.
Field Attributes
• System Name – Name assigned to the ECN330-switch.
• Object ID – MIB II object ID for ECN330-switch’s network management
subsystem.
• Location – Specifies the system location.
• Contact – Administrator responsible for the system.
• System Up Time – Length of time the management agent has been up.
These additional parameters are displayed for the CLI.
• MAC Address – The physical layer address for the ECN330-switch.
• Web server – Shows if management access through HTTP is enabled.
• Web server port – Shows the TCP port number used by the web
interface.
• Web secure server – Shows if management access through HTTPS is
enabled.
• Web secure server port – Shows the TCP port used by the HTTPS
interface.
• Telnet server – Shows if management access through Telnet is
enabled.
• Telnet server port – Shows the TCP port used by the Telnet interface.
• Jumbo Frame – Shows if jumbo frames are enabled.
• POST result – Shows results of the power-on self-test
To Next Page
Loading...
