Configuring the ECN330-switch
184 1553-KDU 137 365 Uen D 2006-06-16
6.7 Port Configuration
6.7.1 Displaying Connection Status
The Port Information or Trunk Information pages can be used to display the
current connection status, including link state, speed/duplex mode, flow control,
and auto-negotiation.
Field Attributes (Web)
• Name – Interface label.
• Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)
• Admin Status – Shows if the interface is enabled or disabled.
• Oper Status – Indicates if the link is Up or Down.
• Speed Duplex Status – Shows the current speed and duplex mode.
(Auto or fixed choice)
• Flow Control Status – Indicates the type of flow control currently in
use. (IEEE 802.3x, Back-Pressure or None)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Media Type – Shows the forced or preferred port type to use for
combination ports
25-26. (Copper-Forced, SFP-Forced, SFP-Preferred-
Auto)
(This parameter is displayed for Port Information only.)
• Trunk Member – Shows if port is a trunk member. (This parameter is
displayed for Port Information only.)
• Creation – Shows if a trunk is manually configured or dynamically set
through LACP. (This parameter is displayed for Trunk Information only.)
To Next Page
Loading...
