Command Line Interface
8131553-KDU 137 365 Uen D 2006-06-16
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the Spanning
Tree Algorithm. If the path cost for all ports on an ECN330-switch are
the same, the port with the highest priority (that is, lowest value) will be
configured as an active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port with
the lowest numeric identifier will be enabled.
Example
Related Commands
spanning-tree cost (section 7.15.16 on page 811)
7.15.18 spanning-tree edge-port
This command specifies an interface as an edge port. Use the no form to restore
the default.
Syntax
[no] spanning-tree edge-port
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Console(config-if)#
To Next Page
Loading...
