Ericsson ECN330 User Manual

Command Line Interface
1028 1553-KDU 137 365 Uen D 2006-06-16
7.26 IP Routing Commands
After network interfaces are configured for the , the paths used to send traffic
between different interfaces must be set. If routing is enabled on the ECN330-
switch, traffic will automatically be forwarded between all of the local
subnetworks. However, to forward traffic to devices on other subnetworks, either
configure fixed paths with static routing commands, or enable a dynamic routing
protocol that exchanges information with other routers on the network to
automatically determine the best path to any subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to
connect the ECN330-switch to the enterprise network.
Table 125 IP Routing Commands
Command Group Function Page
Global Routing
Configuration
Configures global parameters for static and dynamic routing,
displays the routing table, and statistics for protocols used to
exchange routing information
1029
Routing Information
Protocol (RIP)
Configures global and interface specific parameters for RIP 1035
Open Shortest Path
First (OSPF)
Configures global and interface specific parameters for OSPF 1053

Ericsson ECN330 Specifications

General

Brand	Ericsson
Model	ECN330
Category	Network Router
Language	English