Ericsson ECN330 - Enabling Lacp on Selected Ports

Configuring the ECN330-switch
1931553-KDU 137 365 Uen D 2006-06-16
CLI – This example creates trunk 1 with ports 9 and 10. Just connect these ports
to two static trunk ports on another switch to form a trunk.
6.7.3.2 Enabling LACP on Selected Ports
Figure 72 Configuring Dynamic Trunks
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/9
Console(config-if)#channel-group 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port Type: 100TX
Mac address: 00-00-E8-AA-AA-01
Configuration:
Name:
Port Admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Flow Control: Disabled
Port Security: Disabled
Current status:
Created By: User
Link Status: Up
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/9, Eth1/10,
Console#
active
links
}
}
dynamically
enabled
configured
members
backup
link