Command Line Interface
5411553-KDU 137 365 Uen D 2006-06-16
Device Designation Commands
This section describes commands used to configure information that uniquely
identifies the ECN330-switch.
Table 35 Device Designation Commands
7.5.1 hostname
This command specifies or modifies the host name for the ECN330-switch. Use
the no form to restore the default host name.
Syntax
hostname <name>
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Command Function Mode Page
hostname Specifies the host name for the ECN330-switch GC 541
snmp-server
contact
Sets the system contact string GC 613
snmp-server
location
Sets the system location string GC 614
To Next Page
Loading...
