Command Line Interface
802 1553-KDU 137 365 Uen D 2006-06-16
Related Commands
spanning-tree forward-time (section 7.15.3 on page 799)
spanning-tree hello-time (section 7.15.4 on page 800)
7.15.6 spanning-tree priority
This command configures the spanning tree priority globally for the ECN330-
switch. Use the no form to restore the default.
Syntax
spanning-tree priority <priority >
no spanning-tree priority
priority - Priority of the bridge. (Range: 0 - 65535)
(Range – 0-61440, in steps of 4096; Options: 0, 4096, 8192, 12288,
16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056, 49152,
53248, 57344, 61440)
Default Setting
32768
Command Mode
Global Configuration
Command Usage
Bridge priority is used in selecting the root device, root port, and designated
port. The device with the highest priority (highest number) becomes the STA
root device. However, if all devices have the same priority, the device with
the lowest MAC address will then become the root device.
Example
Console(config)#spanning-tree priority 16384
Console(config)#
To Next Page
Loading...
