Command Line Interface
626 1553-KDU 137 365 Uen D 2006-06-16
• When authentication is selected, the MD5 or SHA algorithm is used as
specified in the snmp-server user command.
• When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
• For additional information on the notification messages supported by
the ECN330-switch, see the ECN330 Alarm Description. Also, note that
the authentication, link-up and link-down messages are legacy traps
and must therefore be enabled in conjunction with the snmp-server
enable traps command (section 7.6.7 on page 618).
Example
7.6.13 show snmp group
Four default groups are provided – SNMPv1 read-only access and read/write
access, and SNMPv2c read-only access and read/write access.
Command Mode
Privileged Exec
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
Console#show snmp group
Group Name: r&d
Security Model: v3
Read View: defaultview
Write View: daily
Notify View: none
Storage Type: permanent
Row Status: active
To Next Page
Loading...
