Ericsson ECN330 - Global Routing Configuration

Command Line Interface
10291553-KDU 137 365 Uen D 2006-06-16
Global Routing Configuration
This section describes commands used to configure global parameters for static
and dynamic routing on the ECN330-switch.
Table 126 Global Routing Configuration Commands
7.26.1 ip routing
This command enables IP routing. Use the no form to disable IP routing.
Syntax
[no] ip routing
Default Setting
Enabled
Command Mode
Global Configuration
Command Function Mode Page
ip routing Enables static and dynamic IP routing GC 1029
ip route Configures static routes GC 1030
clear ip route Deletes specified entries from the routing table PE 1031
show ip route Displays specified entries in the routing table PE 1032
show ip host-
route
Displays displays the interface associated with
known routes
PE 1033
show ip
traffic
Displays statistics for IP, ICMP, UDP, TCP and ARP
protocols
PE 1034