Command Line Interface
8411553-KDU 137 365 Uen D 2006-06-16
7.17 VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify
how VLAN tagging is used, and enable automatic VLAN registration for the
selected interface.
Table 89 VLAN Commands
Command Groups Function Page
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic VLAN
learning; shows the configuration for bridge extension MIB
842
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 848
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress
and egress tagging mode, ingress filtering, PVID, and
GVRP
855
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC
addresses
865
Configuring Private
VLANs
Configures private VLANs, including uplink and downlink
ports
868
Configuring Protocol
VLANs
Configures protocol-based VLANs based on frame type
and protocol
877
Configuring 802.1Q
Tunneling
Configures IEEE 802.1Q tunneling (QinQ) to segregate
and preserve customer VLAN IDs for traffic crossing the
service provider network
882
To Next Page
Loading...
