Command Line Interface
854 1553-KDU 137 365 Uen D 2006-06-16
Example
This example shows how to change a management VLAN. First set up a new
VLAN with the required port members (without naming the VLAN), remove the
current FSA management VLAN, and then configure the newly configured VLAN
as the new FSA management VLAN.
Related Commands
show management vlan (section 7.17.15 on page 868)
Console#configue
Console(config)#vlan database
Console(config-vlan)#vlan 349 media ethernet state active
Console(config)#exit
Console(config)#interface ethernet 1/1
Console(config-if)#switchport allowed vlan add 349 tagged
.
.
.
Console(config)#exit
Console(config)#interface ethernet 1/24
Console(config-if)#switchport allowed vlan add 349 tagged
Console(config)#exit
Console(config)#interface ethernet 1/28
Console(config-if)#switchport allowed vlan add 349 tagged
Console(config)#exit
Console(config)#no management vlan fsa
Console(config)#management vlan fsa 349
Console#show management vlan
Current Internal Management VLAN: 247
Current Dynamic Management VLAN: 248
Current External Management VLAN: 246
Current Native Management VLAN: 4093
Current FSA Management VLAN: 349
Console#
To Next Page
Loading...
