Command Line Interface
856 1553-KDU 137 365 Uen D 2006-06-16
7.17.5 interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure a physical interface.
Syntax
interface vlan <vlan-id>
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading
zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode to
VLAN 1, and then assign an IP address to the VLAN:
Related Commands
shutdown (section 7.9.8 on page 746)
Console(config)#interface vlan 246
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
To Next Page
Loading...
