Ericsson ECN330 - Show Power Inline Status

Command Line Interface
7831553-KDU 137 365 Uen D 2006-06-16
Command Usage
• If the power demand from devices connected to the ECN330 exceeds
the power budget setting, the ECN330-switch uses port power priority
settings to control the supplied power. For example:
• A device connected to a low-priority port that causes the ECN330
to exceed its budget is not supplied power.
• A device connected to a critical or high-priority port that causes the
ECN330 to exceed its budget is supplied power, but the ECN330-
switch drops power to one or more lower-priority ports.
• Power is dropped from low-priority ports in sequence starting from port
number 1.
Example
Related Commands
power mainpower maximum allocation (section 7.13.1 on page 779)
7.13.5 show power inline status
This command displays the current power status for all ports or for specific ports.
Syntax
show power inline status [interface]
interface
ethernet unit/port
• unit - This is device 1.
• port - Physical port number on the ECN330 (Range: 1-24).
Console(config)#interface ethernet 1/1
Console(config-if)#power inline priority 3
Console(config-if)#