Ericsson ECN330 - Address Table Commands

Command Line Interface
786 1553-KDU 137 365 Uen D 2006-06-16
7.14 Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging
time.
Table 84 Address Table Commands
Command Function Mode Page
mac-address-
table static
Maps a static address to a port in a VLAN GC 787
clear mac-
address-table
dynamic
Removes any learned entries from the forwarding
database
PE 788
show mac-
address-table
Displays entries in the bridge-forwarding database PE 789
mac-address-
table aging-
time
Sets the aging time of the address table GC 791
mac-address-
table
threshold
Sends a trap message when address entries exceed
a specified threshold
GC 792
show mac-
address-table
aging-time
Shows the aging time for the address table PE 793