Command Line Interface
7871553-KDU 137 365 Uen D 2006-06-16
7.14.1 mac-address-table static
This command maps a static address to a destination port in a VLAN. Use the
no form to remove an address.
Syntax
mac-address-table static <mac-address> interface
<interface> vlan <vlan-id> [action]
no mac-address-table static <mac-address> vlan <vlan-id>
• mac-address - MAC address.
interface
• ethernet <unit>/<port>
• unit - This is device 1.
• port - Physical port number on the ECN330
(Range: 1-28).
• port-channel <channel-id> - The assigned number of an
aggregated link (Range: 1-13)
• vlan-id - VLAN ID (Range: 1-4094)
• action -
• delete-on-reset - Assignment lasts until the ECN330-
switch is reset.
• permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
To Next Page
Loading...
