Ericsson ECN330 - Switchport Acceptable-Frame-Types

Command Line Interface
858 1553-KDU 137 365 Uen D 2006-06-16
Related Commands
switchport acceptable-frame-types (section 7.17.7 on page 858)
7.17.7 switchport acceptable-frame-types
This command configures the acceptable frame types for a port. Use the no
form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port accepts all frames, tagged or untagged.
• tagged - The port only passes tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that are untagged
are assigned to the default VLAN.
Example
The following example shows how to restrict the traffic passed on port 1 to
tagged frames:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#