Command Line Interface
6871553-KDU 137 365 Uen D 2006-06-16
IP Filter Commands
This section describes commands used to configure IP management access to
the ECN330-switch.
Table 66 IP Filter Commands
7.7.45 management
This command specifies the client IP addresses that are allowed management
access to the ECN330-switch through various protocols. Use the no form to
restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client
| telnet-client} <start-address> [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a
range.
• end-address - The end address of a range.
Command Function Mode Page
management Configures IP addresses that are allowed management
access
GC 687
show
management
Displays the client IP addresses that are allowed
management access to the ECN330-switch
PE 689
To Next Page
Loading...
