Command Line Interface
688 1553-KDU 137 365 Uen D 2006-06-16
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the ECN330-
switch from an invalid address, the ECN330-switch will reject the
connection, enter an event message in the system log, and send a trap
message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
• When entering addresses for the same group (that is, SNMP, web or
Telnet), the ECN330-switch will not accept overlapping address ranges.
When entering addresses for different groups, the ECN330-switch will
accept overlapping address ranges.
• An individual address cannot be deleted from a specified range. The
entire range must be deleted and the addresses reentered.
• An address range can be deleted just by specifying the start address, or
by specifying both the start address and end address.
Example
This example restricts management access to the indicated addresses.
Console(config)#management all-client 192.168.1.19
Console(config)#management all-client 192.168.1.25 192.168.1.30
Console#
To Next Page
Loading...
