Ericsson ECN330 - Show Sntp

Command Line Interface
604 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
This command is only applicable when the ECN330-switch is set to SNTP
client mode.
Example
Related Commands
sntp client (section 7.5.46 on page 601)
7.5.49 show sntp
This command displays the current time and configuration settings for the SNTP
client, and whether or not the local time has been properly updated.
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command displays the current time, the poll interval used for sending
time synchronization requests, and the current SNTP mode (that is,
unicast).
Example
Console(config)#sntp poll 60
Console#
Console#show sntp
Current time: Dec 23 05:13:28 2002
Poll interval: 16
Current mode: unicast
SNTP status : Enabled
SNTP server 137.92.140.80 0.0.0.0 0.0.0.0
Current server: 137.92.140.80
Console#