Ericsson ECN330 User Manual

Command Line Interface
974 1553-KDU 137 365 Uen D 2006-06-16
7.23 Dynamic Host Configuration Protocol Commands
These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client, relay, and server functions. Any VLAN interface can be
configured to be automatically assigned an IP address through DHCP. The
ECN330-switch can be configured to relay DHCP client configuration requests
to a DHCP server on another network, or it can be configured to provide DHCP
service directly to any client.
Table 114 DHCP Commands
DHCP Client
Use the commands in this section to allow ECN330-switch VLAN interfaces to
dynamically acquire IP address information.
Table 115 DHCP Client Commands
Command Group Function Page
DHCP Client Allows interfaces to dynamically acquire IP address
information
974
DHCP Relay Relays DHCP requests from local hosts to a remote DHCP
server
977
DHCP Server Configures DHCP service using address pools or static
bindings
980
Command Function Mode Page
ip dhcp client-
identifier
Specifies the DHCP client identifier for the
ECN330-switch
IC 975
ip dhcp restart
client
Submits a BOOTP or DHCP client request PE 976

Ericsson ECN330 Specifications

General

Brand	Ericsson
Model	ECN330
Category	Network Router
Language	English