Command Line Interface
608 1553-KDU 137 365 Uen D 2006-06-16
7.6 Simple Network Management Protocol Commands
The commands in this group control access to the ECN330-switch from
management stations using the Simple Network Management Protocol (SNMP).
SNMP is used by the Public Ethernet Manager (PEM) to communicate with the
ECN330-switch, and by the ECN330-switch to send alarms (traps) to the PEM.
SNMP Version 3 provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific
areas of the MIB tree. To use these commands, first configure an SNMP engine
ID (or accept the default), specify read and write access views for the MIB tree,
configure SNMP user groups with the required security model (that is, SNMP v1,
v2c or v3) and security level (that is, authentication and privacy), and then assign
SNMP users to these groups, along with their specific authentication and privacy
passwords.
Table 49 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent GC 609
show snmp Displays the status of SNMP communications NE,
PE
610
snmp-server
community
Sets up the community access string to permit
access to SNMP commands
GC 612
snmp-server
contact
Sets the system contact string GC 613
snmp-server
location
Sets the system location string GC 614
snmp-server host Specifies the recipient of an SNMP notification
operation
GC 615
snmp-server
enable traps
Enables the device to send SNMP traps (SNMP
notifications)
GC 618
snmp-server
engine-id
Sets the SNMP engine ID GC 619
To Next Page
Loading...
