Command Line Interface
9811553-KDU 137 365 Uen D 2006-06-16
7.23.5 service dhcp
This command enables the DHCP server on the ECN330-switch. Use the no
form to disable the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
If the DHCP server is running, it must be restarted to implement any
configuration changes.
host* Specifies the IP address and network mask to
manually bind to a DHCP client
DC 992
client-identifier* Specifies a client identifier for a DHCP client DC 993
hardware-address* Specifies the hardware address of a DHCP
client
DC 994
clear ip dhcp
binding
Deletes an automatic address binding from the
DHCP server database
PE 995
show ip dhcp
binding
Displays address bindings on the DHCP server PE,
NE
996
* These commands are used for manually binding an address to a client.
Command Function Mode Page
To Next Page
Loading...
