Management Features Overview
30 1553-KDU 137 365 Uen D 2006-06-16
4.3 System Defaults
The ECN330-switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg” To reset the ECN330-switch defaults, this file
should be set as the startup configuration file. (See section 7.5.18 on page 568.)
Table 6 lists some of the basic system defaults.
Table 6 System Defaults
Function Parameter Default
Console Port
Connection
Baud Rate 9600
Data bits 8
Stop bits 1
Parity none
Local Console Timeout 0 (disabled)
To Next Page
Loading...
