Command Line Interface
948 1553-KDU 137 365 Uen D 2006-06-16
• Report suppression is not supported when multicast query messages
include IGMPv3 reports.
Example
7.21.12 ip igmp snooping router-port-expire-time
This command configures the query timeout. Use the no form of this command
to restore the default.
Syntax
ip igmp snooping router-port-expire-time <seconds>
no ip igmp snooping router-port-expire-time
seconds - The time the ECN330-switch waits after the previous querier
stops before it considers the router port (the interface which had been
receiving query packets) to have expired. (Range: 300-500)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The ECN330-switch must use IGMPv2 or v3 snooping for this command to
take effect.
Console(config)#ip igmp snooping report suppression
Console(config)#
To Next Page
Loading...
