Command Line Interface
9471553-KDU 137 365 Uen D 2006-06-16
Example
The following shows how to configure the maximum response time to
20 seconds:
Related Commands
ip igmp snooping version (section 7.21.4 on page 939)
ip igmp snooping query-max-response-time (section 7.21.10 on
page 946)
7.21.11 ip igmp snooping report-suppression
This command restricts the number of IGMP report messages sent to multicast
devices. Use the no form of this command to disable report suppression and
forward all IGMP reports.
Syntax
[no] ip igmp snooping report-suppression
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• IGMP report suppression is used to forward only one IGMP report per
query to multicast devices. When IGMP router suppression is enabled,
the ECN330-switch sends the first IGMP report from all hosts for a
group to all the multicast routers.
Console(config)#ip igmp snooping query-max-response-time 200
Console(config)#
To Next Page
Loading...
