Command Line Interface
10791553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
ip ospf hello-interval (section 7.26.37 on page 1079)
7.26.37 ip ospf hello-interval
This command specifies the interval between sending hello packets on an
interface. Use the no form to restore the default value.
Syntax
ip ospf hello-interval <seconds>
no ip ospf hello-interval
seconds - Interval at which hello packets are sent from an interface.
This interval must be set to the same value for all routers on the network.
(Range: 1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
10 seconds
Command Usage
Hello packets are used to inform other routers that the sending router is still
active. Setting the hello interval to a smaller value can reduce the delay in
detecting topological changes, but will increase routing traffic.
Console(config)#interface vlan 1
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#
To Next Page
Loading...
